Kitchenaid aufsätze wechseln

It’s a good idea to have your camera ready to capture the orientation of these parts before you remove the housing.

This is where you’ll most likely be looking if you suspect a KitchenAid gear replacement is needed. Be prepared for small gears and spacers to potentially fall out if not handled carefully. Auch für KitchenAid-Standmixer und KitchenAid-Toaster bieten wir eine Auswahl an KitchenAid-Zubehör und KitchenAid-Ersatzteilen an.

Individuelle Beratung für die Auswahl Ihres KitchenAid-Ersatzteils oder KitchenAid-Zubehörs

Wir legen großen Wert auf eine persönliche und kompetente Beratung.

It can sometimes slip or fail.

Reassembly: Putting it All Back Together

Reassembly is the reverse of disassembly, but requires just as much care.

1. Reverse the Steps: Follow your photos and notes to put everything back in the order it came apart.
2. Connect Wires: Ensure all electrical connections are secure.
3. Align Parts: Make sure gears, shafts, and housings are properly aligned before tightening screws.
4. Lubricate: If you replaced gears or found dry bearings, apply a small amount of appropriate lubricant (usually food-grade grease for gears).
5. Tighten Screws: Don’t overtighten screws, especially in plastic housings, as this can strip the threads.

   Issues like grinding noises or a mixer that runs but the beater doesn’t move often point to problems here.

   Step 5: Removing the Top Housing and Control Panel

   To access the planetary gear housing, you often need to remove the top section of the mixer head.

   • Unscrew Top Housing: Look for screws securing the top housing, often located on the back or sides of the tilt-head section.
   • Disconnect Wiring (if necessary): Some models may have wires connecting the speed control or power switch to the motor.

     Some models might have rubber feet that need to be gently pried off to reveal hidden screws.

   • Use the Correct Screwdriver: Select the appropriate screwdriver bit (usually Phillips) and unscrew each fastener. If the motor is still strong and the main housing is in good condition, replacing worn-out KitchenAid mixer parts like gears or belts can give your mixer many more years of service.

     By following this detailed guide, you should feel more confident in performing your own KitchenAid mixer disassembly for inspection and repair.

     This often means accessing the head of the mixer.

     Step 3: Removing the Head Cover Screws

     The head of the mixer, which houses the planetary gear system and the attachment hub, is typically secured by screws.

     • Locate Head Screws: These are usually found at the back of the mixer head or sometimes on the sides, near where the tilt-lock mechanism is.
     • Remove Screws: Unscrew these fasteners, again, keeping them organized.

     Step 4: Separating the Mixer Head Cover

     Similar to the base cover, the head cover might require gentle prying.

     • Pry Gently: Use your plastic pry tools to carefully separate the head cover from the main mixer body.

       However, if you notice unusual noises, slower performance, or loss of power, it’s a good time to inspect and potentially perform KitchenAid mixer repair.
       
       Package includes:
       1 x Silicone Stand Blender Bowl Inserts